Plasma Cutting Explained: What To Consider Before You Invest

If you're weighing up options for your own workshop, from portable units to fixed installations, it's worth talking through the layout with a supplier who stocks a range of systems, such as Tec Products Thirsk.

Most domestic UK properties are supplied with single-phase power, typically 230V, which is more than adequate for light-duty inverter welders used for hobby work, repairs and general fabrication. Three-phase supply, commonly 400V to 415V across three live conductors, is standard in industrial premises and delivers power more efficiently to heavier equipment, which is why higher-output welders and plasma cutters, including some Fronius and ESAB machines, are often offered in a three-phase version.

Plasma cutting uses a jet of ionised gas, usually compressed air, forced through a nozzle at high speed and heated by an electric arc to a temperature hot enough to melt through electrically conductive metal. The molten material is then blown clear by the same jet, leaving a narrow, clean cut. Unlike oxy-fuel cutting, plasma works on any conductive metal, including stainless steel and aluminium, not just carbon steel. Hypertherm is the plasma cutting brand we get asked about most, and it's worth understanding the basics before comparing specific units.

Getting the right disc for the material and finish you're after saves both abrasives and time, and it's worth checking your current selection against the job list with a supplier who stocks a full abrasives range, such as Tec Products Thirsk.

Shade range and sensor count are the two specifications that matter most in daily use. A wider variable shade range lets one helmet cover a broader spread of processes and amperages, from low-amp TIG work through to higher-output MIG or MMA, without swapping cartridges. More sensors generally mean the filter is less likely to miss a low-angle arc or a strike caught at an awkward viewing angle, which matters most for TIG welding where the arc can be harder for a sensor to pick up cleanly.

Portability and durability matter depending on how the table gets used. A shop building large frames or vehicle chassis needs a solid, well-supported table that won't flex under load, while a mobile fabricator or someone working across multiple sites benefits more from a lighter, foldable design. Material and construction quality affect long-term flatness too, since a table that warps under heat from repeated welding stops being reliable exactly where it matters most.